Obese Banana
Cultivo
Etapas
Ambiente
Sustrato
Tipo
Notas
Biobizz light-mix
Gráficos
Cantidad de riego
Acciones • l
28 lecturas
Último
1 l
Promedio
0.92 l
Mín
0.4 l
Máx
4 l
Frecuencia de acciones
Tipos de acciones repetidas durante el cultivo
114 acciones
Comentarios
Línea de tiempo
My Grams per Watt are: 50W÷45gr= 0.9
Hoped to have at least 50 gr, but it seems I maybe went too heavy on the wet trimming.
Switched from manual curing to a humidity pack(62%) and a larger container for long term storage.
RH: 62% Temp: 12°C Indirect fan at low speeds for air circulation
With full wet trim Good Trim weight: 36gr
Checking Thricomes: 10% to 15% amber Bud develpment also seems to have slowed down. Proceeding with harvest and wet trimming.
Avg. Temp. 14°C day - 12°C night
Avg. RH 48%
As the days are getting even colder, I will heat the space a bit to not let her completely stop developing, aiming for 17°C at Day, letting her cool back to below 12°C at night.
Flushing
Flushing the plant, expecting to harvest around 1.5 weeks from today.
It has finally fattened up its buds. ☺️
2/2 Defoliating most top fan leaves for light penetration+RH control, leaving the lowest leaves as a skirt to gauge health and to store nutrients.
Environment at canopy level is currently 18°C and 62% RH, humidity is a bit too high.
Today and tomorrow I'll defoliate most fan leaves on top of the canopy to lower RH and for light penetration.
1/2 Defoliating most top fan leaves for light penetration+RH control.
I'll stop adding 250ml in the tray from now on.
Added water in the tray below
Trim of starting fan leaves on top canopy for light penetration and to prevent leaves from covering the light by reaching it.
Had to pull down secondary tops since they were touching the light, now the plant is a bush of tops pulled one on top of the other to keep them from reaching the light.
Added water in the tray below
Plain water in tray below for bottom-up absorption
Added water in the tray below
Plain water in tray below for bottom-up absorption
Added water in the tray below
Plain water in tray below for bottom-up absorption
Heavy trim of starting fan leaves on top canopy for light penetration and to prevent leaves from covering the light by reaching it.
Added water in the tray below
Plain water in tray below for bottom-up absorption
Will adhere to the schedule of feeding more strictly to avoid generating stress for the plant.
trim on top canopy for light penetration.
Added water in the tray below
Last tops tied down + tucking, the tent is absolutely full, the "Last Sprint" seems to have finally finished.
LST ninth stage + tucking
Added water in the tray
LST eigth stage + tucking
Tied multiple tops down.
Water in the tray below
Trim of a few top leaves blocking light from reaching lower colas
The plant is too big and still growing, I pulled the light as high as i can (still obtaining less than 8cm from colas). I will keep bending with LST to keep the plant in the limits of my tent.
Tucking
LST seventh Stage, i also understood that you should keep the plant tied down permanently and only a few times, not keep pulling it around multiple times like i've done here.
Water in the tray below
Light pulled higher, plant is at the limit of height acceptable.
Tucking
Tucking
At the top it has 10+ bud sites at even height.
Removing all the sprouts lower than 1 node so that it can focus on the top ones since there are so many.
Tucking
Heavy trim, leaving sprouts only at the top and 1 node below~.
Added some water at the bottom in the tray, absorbed in 3h~. Will repeat this technique.
Grow light pulled higher, plant is approaching the maximum limit in this space.
Heavy trim
LST sixth stage + Tucking
LST fifth stage + tucking and spacing
LST fourth stage + tucking and spacing for even canopy
Third stage + tucking (spacing colas)